You can read the above-mentioned article, which walks through the steps to perform a repair install. However, you will not lose any data or applications. A repair install will basically replace all of the Windows system files with new ones from the CD. If none of the recovery console commands work, you may have to perform a repair install. Read the following article to learn how to disable a service or disable a driver using the Recovery Console: You can also use the Recovery Console to enable/disable a faulty service or driver. sfc /scannow – This command will scan all the Windows system files and replace any corrupted ones with working ones. bootcfg /rebuild – This will rebuild the boot.ini file in case it got corrupted during an attempt to modify it or in a dual boot situation.Ĥ. Note this command is available in Windows XP only.ģ. fixboot – Will write a new partition boot sector to the system partition. The /r switch will repair any errors autoamtically.Ģ. chkdsk /r – The chkdsk command will check the hard disk for any errors. Once you’re in, you’re going to want to run a few commands. There are several useful commands in the Recovery Console that might be able to fix the boot problem with Windows XP or Windows 7.įirstly, check out my previous article on how to fix a missing or corrupt NTFS.sys file, which shows you how to get into the Recovery Console. The recovery console can be your best friend in situations like this. In this article, I will try to compile all the resources I have found for fixing this problem. Reasons can be anything from your mass storage driver becoming corrupted to the hard drive having disk errors to a corrupted registry.

Unfortunately, there are many reasons why Windows won’t boot into Safe Mode. However, there are certain times when you can’t even boot into Safe Mode! When that happens in Windows, you know that’s not good. At this point, you can try to fix whatever issue is causing problems. Usually when something goes wrong in Windows, we can fix it by restarting the computer and going into Safe Mode, which basically loads the bare essentials that are needed for Windows to run.

How to enter safe mode xp